As noted in my previous install post (https://blog.terenceluk.com/what-installing-forefront-unified/), the following is the configuration process I went through during the deployment of UAG for DirectAccess: Once I rebooted the server after
While this post isn’t anything special, I had to document an install I did for UAG so I thought I might as well make good use of the documentation and
I’m sure a lot of Exchange UM professionals out there already know this but in case the person reading this doesn’t: Ever wonder where Exchange 2007 pulls the Extension Configuration
I wouldn’t say this was extremely interesting but wanted to write a short post to remind myself what was done in case I run into this again in the future.
I was able to successfully install SmartSIP as per my last post (https://blog.terenceluk.com/problems-installing-nets-smartsip-run/) but ran into a minor snag when I tried to start the services and this screen is
Yes, it almost sounds like I had a heck of a lot of issues installing SmartSIP but note the following: I wasn’t using the right package one of the times.
I’m not sure what caused this error when I was uninstalling SmartSIP so I won’t assume that it’s because of the application but rather a combination of the server being
The SmartSIP blog posts are a bit out of sync as I’ve posted a troubleshooting one earlier last week but so sorry about the ordering. Problem Went ahead through the
